Ganesh GT-3080 Series CNC Lathe (10″ Bar Capacity) With Fanuc 0i-T-D (Manual Guide i)

Ganesh GT-3080 Series CNC Lathe (10″ Bar Capacity) With Fanuc 0i-T-D (Manual Guide i)

Contact us for price

Hubbard, TX

orCall 817-714-9839


Swing over Bed 30” (760 mm) Swing over Cross Slide 19” (480 mm) Center Height 15” (380 mm) Bed width of ways 18” (460 mm) Bed Casting Height 15.75” (400 mm) Big-Bore Spindle Option – Bore Size 10” A2-15 spindle Big-Bore Spindle Gear Ranges – 2-automatically selected gear ranges Low 18-186 rpm / High 60-600 rpm Spindle Torque for 10” bore – low gear / high gear  1475 / 442 ft. lbs. (2000 / 600 Nm) Workpiece weight limit when held in chuck 1,100 lbs. (500kgs) Workpiece weight limit when held by chuck and tailstock 2,200 lbs. (1,000kgs) Workpiece weight limit when held by chuck, steady rest & tailstock 4,400 lbs. (2,000kgs) X-Axis Cross slide travel 19-5/8” (500 mm) Z-Axis Ball screw Diameter / Servo Motor Power 2” (50 mm) / 4.0-HP (2.9kw) Tool stations – any combination of ID/OD tooling /Index time  8-stations / 0.4 second index O.D. Tailstock-Air-Assist Manual Positioning – Quill engraved with inch / metric quill graduations Quill diameter Ø5.0” (125 mm) Quill stroke (manual quill advance, hydraulic optional) 8″ (200 mm) Electrical / Hydraulic / Coolant Systems Power Requirements – FANUC 0i-TD control, motors & drives  30kVA, 220vac ±5%, Hydraulic Motor Power 2-H.P. Equipped With: FANUC 0i-TD (With Manual Guide i) 24″ 3 Jaw Manual Chuck (10″ Bore) Chip Conveyor Steady Rest


Spindle motor horsepower (fanuc 18.5kw)30-HP Peak (25-HP 30-min. rated)
Spindle speeds18-600 rpm (2-ranges)
Rapid traverse feedrate x&z394 IPM  (10m/min)
Z-axis longitudinal travel96”
X-axis ball screw diameter / servo motor power1.25” (32 mm) / 3.5-HP (2.5kw)
X-axis thrust65 ft. lbs. (900 Kgf)
Z-axis thrust98 ft. lbs. (1350 Kgf)
Cross slide dimensions wxl39” x 10” (1000mm x 258mm)
Minimum input unit0.0001” (0.001mm = 40 millionths”)
Tool turret-Hydraulic type / LS-200R
Tooling (additional i.d. & o.d. toolholders in stock)1” tools w/8-tool clamps provided I.D.
Tooling (40mm when specified for metric users)4-ID (1.5” bore) holders provided
Quill taperMorse Taper # 6
Hydraulic pressure500 PSI / Mobil #32 oil
Coolant pump3/4-HP